stockpile - Designate members of a \*Qstockpile\*U





The stockpile command is used to specify the stockpile groupings of your nukes.

[##:##] Command : stockpile <STOCKPILE> <NUKE/STOCKPILE>

In the syntax <STOCKPILE> is the alphabetic character to be used as the stockpile designation. This character can be chosen from the set of upper or lower case a-z and tilde (~). The pseudo-stockpile specification tilde specifies all nukes not currently in any stockpile.

The specification of nukes, <NUKE/STOCKPILE>, can have one of several syntaxes:

example     meaning
23          nuke 23
2/14/23     nukes 2, 14, and 23
c           all nukes currently in stockpile `c'
~           all nukes currently in the "null" stockpile
2,3         all nukes in sector 2,3
-1:3,0:2    all nukes in the square area bounded by -1,0 & 3,2

All stockpiles, (with the exception of the `~' stockpile), are limited to some maximum size and you will be informed how many nukes can be added when this command is run.

Having nukes organized into stockpiles can be very helpful in loading, moving, etc., in that fewer commands are required to perform these commands on groups of nukes if they can be specified by stockpile number.

Note that you can remove nukes from a stockpile by adding them to the `~' stockpile. e.g.

[##:##] Command : stockpile ~ A

This command would purge all nukes from stockpile `A'.


nuke, transport, Nukes

Community content is available under CC-BY-SA unless otherwise noted.